Merino Wool Sweater: Elita Top / Jacket by Style Arc

A few months ago I made the Style Arc's Elita Designer Top / Jacket in a boiled wool.  And since then I've want to sew a sweater knit version.  Finally, it's done after a few tweaks to the pattern.  

1. The hemlines were shortened; two inches on the bodice and two and a half inches on the sleeve length.  
2. The front curve near the bustline was widened
3. And addition of width at the back to provide more ease. 
4. The edges were finished with the machine roll hem feature on my serger.   
5. The ties were left off, I'll style it with a brooch instead.  

The sleeves are still a little long but I don't mind rolling it up once.  The pattern is lovely it's a keeper.  I like how it fits and I'll be able to wear this over the back brace if need be.  

The fabric makes this top.  It is made in a merino wool knit, a beautiful previously owned fabric that I picked up at Winnipeg Sews.  I feel very lucky to have found it.  And I will admit that it lingered in my own stash for quite some time because I was afraid to cut into it.  I was also afraid about shrinkage when it came to pretreating the fabric.  

But I decided that I have been holding onto the fabric for far too long.  I want them to shrink before cutting, not later.  I threw the burgundy colour merino wool jersey in the washing machine on the delicate cycle and used Woolite.  Afterwards it went in the dryer, again in the delicate cycle while I kept my fingers crossed.  I know risky, right?  

The fabric shrank.  I started out with 2.2 metres and in the end there was 2.06 metres.  It also shrank in the width but it came out looking beautiful.  And thankfully even with the shrinkage, I was able to cut out this project.  

The beige wool sweater knit received the same treatment but I didn't lose any length much to my surprise.  I still have to decide on the project.  

So the question, do you pre-treat your fabrics?  

Sewing IS Political

This project is another Canadian 🍁 made and tariff free make.  The Style Arc pattern originates from Australia.  The fabric was found locally at Winnipeg Sews, a now closed fabric outlet.  The threads were from the stash.  

Project details

Seams:  Knit (lightening bolt) stitch

Seam finish:  None.

Fabric:  2 metres

Pattern:  Style Arc's Elita Top / Jacket

Additional Tools and Supplies:  Cutting table, pins, pin cushion, fabric scissors, tailor's chalk, measuring tape, Janome 4120 QDC sewing machine, walking foot, screwdriver, tweezers, canned air, Janome 2000D AirThread Serger, threads, tailor's ham, pressing sleeve, iron, ironing board, measuring gauge, good tunes and tea.  

Stand strong, elbows up and keep sewing.